|
Тема |
Flux |
|
Автор |
Ra4OKowa4a (ентусиаст) |
|
Публикувано | 03.07.06 19:53 |
|
|
High permeable flux core
Both
togled..
Здравейте:)
Ето че съм в клуба на едни от най интелигентните хора по света-преводачите
В всеки от вас живеят поне по два свята
Тук съм понеже се занимавам с реставриране на стари неща в конкретният случай един патент на .... вечна машина представете си! Ми какво да правя като се оказва че има и такива Та, Правя всичко възможно да не занимавам хората напразно имам си Socrat 98-tryall, translo, Bultra имам и много хубави англоруски и руско българскио речници... Но ето че ми се налага да Ви занимавам въпреки това .Моля преведете ми ето този абзац .Друго ако не ще знаете за нататък като какво нещо е една вечна машина(е, или полувечна защото като и се изтъркат частите нали разбирате:)))
Ето текста:
"Good Karma:
The last shirt has no pockets !
50 % of the license MUST be
donated to charity I
by Dipl. Ing. Stefan Hartmann harti@harti.com
copyright 2002 by www.overunity.com
released 23th of Sept. 2002
principle circuit diagram:
(corrected version win right coH connections)
based on the too complicated MEG by Steven Sullivan (omnidyne@holmail.com) free for noncommercial personal use all commercial usa must aqujre a license from the author. Use it <st your ovvn risk, I take no responsibility for wrong use !
coupled switching
coupled switching
high permeable flux core must not be in saturation I
R1 and R2 are load resistors
high permeable flux core must not be in saturation I
Working principle:
Both switches must be toggled fast ON and OFF.
This could also be done by electronic switching.
The flux from the permanent magnet is divided equally into each core leg,
when the 2 switches are OFF.
When both switches are toggled ON, the magnetic fields from the coils
pushes the permanent magnet flux from the left core leg into the right core leg,
so all permanent magnet flux is flowing in the right core leg only.
Now when the switches are switched OFF the flux from the right core leg tries
to balance again back to equilibrium state.
As the coils are now connected via the diodes and the 2 load resistors R1 and R2
in the right direction of the Back EMF Voltage, the equilibrium flux change
drives huge energy back to the accumulator and recharges it."
Този текст е малко крив но какво да правя такъв ми е разчитащия софтуер
Не можах да намеря сайта та да копна от там.Пак ще опитам
Благодаря на всеки отзовал се предварително
|
| |
|
|
|